This Configuration Guide is designed to assist members to enhance their skills in particular technology area. While every effort has been made to ensure that all material is as complete and accurate as possible, the enclosed material is presented on an "as is" basis. Neither the authors nor Forum assume any liability or responsibility to any person or entity with respect to loss or damages incurred from the information contained in this guide. This configuration guide was developed by Forum. Any similarities between material presented in this configuration guide and any other material is completely coincidental.
Cisco IOS Software, Linux Software (I86BI_LINUX-ADVENTERPRISEK9-M), Version 15.2(4)M1,
DEVELOPMENT TEST SOFTWARE
Lab created for RST Forum by: Yash Muni, Ritesh Gohil
LAB 1: Configure DHCP
Task 1: Configure IPv4 DHCP
Step 1: In the configuration mode of router configure IPv4 DHCP by following command
Multilayer Switch 1 interface fastethernet 0/1 switchport trunk encapsulation dot1q switchport mode trunk exit vlan 100, 200 exit interface vlan 100 ip address 188.8.131.52 255.255.255.0 interface vlan 200 ip address 184.108.40.206 255.255.255.0 ip dhcp pool VLAN0100 network 220.127.116.11 255.255.255.0 default-router 18.104.22.168 exit ip dhcp pool VLAN0200 network 22.214.171.124 255.255.255.0 default-router 126.96.36.199 exit Switch 1 interface fastethernet 0/1 switchport trunk encapsulation dot1q switchport mode trunk exit interface fastethernet 0/2 switchport access vlan 100 switchport mode access interface fastethernet 0/3 switchport access vlan 200 switchport mode access Configure the HOST to obtain IP from DHCP.